Multilift Staff Estimator v3

Estimating Tool Internal Use Only Prices are indicative. Confirm with Mark/Marcus before quoting. Use price override for site-specific adjustments.

👤 Customer Details

Name *

Phone *

Email *

Postcode *

Installation Address *

Timeframe

How did they hear about us?

Build Type

New Build

Existing Home

Renovation

📐 Technical Requirements

Number of Floors (stops) *

Top Floor Ceiling Height (finished floor to ceiling, mm)

Finished floor to ceiling on the top floor. Typical: 2400×3000mm.

Travel Height (TOTAL bottom floor to top floor, all floors combined, mm)

Total travel distance across ALL floors combined. E.g. 3-floor job with 2,700mm per floor = 8,100mm total. Surcharge applies if per-floor average exceeds 3,000mm.

ML100/ML120: Over 3000mm +$1,800 surcharge (larger shroud, hanging cable, extra track). Over 3500mm not acceptable.
UP300/UP400 (GN): Standard is 3000mm per floor. Total extra shaft height across all floors charged at $718/m.

Wheelchair accessibility required? *

Yes must fit wheelchair

No walking mobility only

Installation location *

InternalInside the home

ExternalOutside / attached

Power supply *

UP200H (Roastek) needs 3-phase for 0.3 m/s. GN-S3 (UP300/UP400) runs fine on single phase.

Structural walls / adequate headroom at top floor?

Yes good headroom & structural walls

No / Not sure low headroom or no structural walls

UP300 (Belt Drive): Requires headroom 2.3 m and at least one structural wall.
UP400 (Slim Cabin): Requires 2.5 m ceiling height the motor unit extends approximately 460 mm above the top landing. Ceilings between 2.5 2.8 m may require modification to battens/rafters to accommodate the overhead mechanism. Your installer will assess on site.
UP200H: Best option when structural wall modifications are not practical.

Primary users

Property Construction

Ground Floor Type *

Upper Floor Type *

Site Access

Site Photos (optional)

Tap to add photos

JPG, PNG, HEIC up to 5

Notes / Questions

Staff Controls

Force model override

Lift price override (AUD excl GST, final price after discount)

Building works override (AUD, replaces calculated)

Site costs scope

"Engineering only" keeps structural eng. fee but removes building works, electrical, painting & plastering from the quote.

Lead time override (weeks)

Assign to

Payment Schedule Overrides

Leave blank for auto-calculated amounts. Override any stage to adjust the quote. Completion payment auto-adjusts to cover the balance.

1. Initial deposit

2. Main deposit

3. Progress (pre-dispatch)

4. On delivery

5. On completion

Internal notes (not shown to customer)

GN & RS extras pricing based on ~0.215 AUD/CNY + 50% markup. Verify exchange rate before sending formal quote.

📋 Estimating tool — indicative pricing only. Confirm with Mark/Marcus before quoting.

🎉 15% OFF SHOWROOM OPENING SPECIAL — Ends 30 May 2026

Applicable Lift Options

📞 Next step: contact customer within 24 hours

Showroom: 4/14 Donaldson St, Wyong NSW (02) 7912 2147

📅 Book Free Showroom Visit

Staff Lift Estimator

Staff Controls

Payment Schedule Overrides

Applicable Lift Options

🔧 Selections